Specifies an array of the ohmic losses inherent to the noise source used in the Y-Factor method. This value is expressed in dB. This loss is accounted for by the NF measurement when you set the NF Y-Factor NS Loss Comp Enabled property to True.

You must specify the frequencies at which the losses were measured using the NF Y-Factor NS Loss Freq property.

You do not need to use a selector string to configure or read this property for the default signal instance. Refer to the Selector Strings topic for information about the string syntax for named signals.

The default value is an empty array.

Remarks

The following table lists the characteristics of this property.

Short Name NF Y-Factor NS Loss (dB)
Data type c1ddbl.png
Permissions Read/Write
High-level VIs N/A
Resettable Yes