ACP

Configures averaging for the adjacent channel power (ACP) measurement.

Configures a carrier channel with offset channels on both sides of the carrier as specified by the number of offsets. The offset channels are separated by +/- n * channel spacing from the center of the carrier. Power is measured over the integration bandwidth for each channel.

Configures the center frequency of the carrier, relative to the RF center frequency.
Use "carrier<       <i>         n       </i>        >" as the selector string to configure this function.

Configures the frequency range, in Hz, over which the measurement integrates the carrier power. Use "carrier<n>" as the selector string to configure this function.

Configures whether to consider the carrier power as part of total carrier power measurement. Use "carrier<n>" as the selector string to configure this function.

Configures the root-raised-cosine (RRC) filter to apply on the carrier channel before measuring the carrier channel power. Use "carrier<n>" as the selector string to configure this function.

Configures the detector settings, including detector type and the number of points to be detected.

Configures window and FFT to obtain a spectrum for the adjacent channel power (ACP) measurement.

Configures the method for performing the adjacent channel power (ACP) measurement.

Configures compensation of the channel powers for the inherent noise floor of the signal analyzer.

Configures the number of carriers for the adjacent channel power (ACP) measurement.

Configures the number of offsets for the adjacent channel power (ACP) measurement.

Configures an offset channel on one or both sides of carrier with center to center spacing as specified by the offset frequency and offset frequency definition. In case of multiple carriers, offset frequency is relative to the closest carrier.
Use "offset<        <i>         n       </i>        >" as the selector string to configure this function.

Configures the offset frequency definition for the ACP measurement. Use "offset<n>" as the selector string to configure this function.

Configures the frequency range, in Hz, over which the measurement integrates the offset channel power. Use "offset<n>" as the selector string to configure this function.

Configures the power reference to use for measuring the relative power of the offset channel.
Use "offset<        <i>         n       </i>        >" as the selector string to configure this function.

Configures the attenuation, in dB, relative to the external attenuation. Use "offset<n>" as the selector string to configure this function.

Configures the root raised cosine (RRC) channel filter to be applied on the offset channel before measuring channel power. Use "offset<n>" as the selector string to configure this function.

Configures the units for the absolute power.

Configures the resolution bandwidth (RBW) filter.

Configures the sweep time.

Indicates whether calibration data is valid for the configuration specified by the signal name in the Selector string parameter.