Specifies an array of the ohmic losses inherent to the noise source used in the Y-Factor method. This value is expressed in dB. This loss is accounted for by the NF measurement when you set the RFMXSPECAN_ATTR_NF_Y_FACTOR_NOISE_SOURCE_LOSS_COMPENSATION_ENABLED attribute to True.

Syntax

RFMXSPECAN_ATTR_NF_Y_FACTOR_NOISE_SOURCE_LOSS

Numeric Value

Data Type

Access

Applies To

1179674

Adouble

Read/Write

N/A

Remarks


You must specify the frequencies at which the losses were measured using the RFMXSPECAN_ATTR_NF_Y_FACTOR_NOISE_SOURCE_LOSS_FREQUENCY attribute.

You do not need to use a selector string to configure or read this attribute for the default signal instance. Refer to the Selector String topic for information about the string syntax for named signals.

The default value is an empty array.