Specifies whether to use the configuration parameters used by the DPD measurement for applying DPD.

Syntax

RFMXSPECAN_ATTR_DPD_APPLY_DPD_CONFIGURATION_INPUT

Numeric Value

Data Type

Access

Applies To

1110049

int32

Read/Write

N/A

Remarks


You do not need to use a selector string to configure or read this attribute for the default signal instance. Refer to the Selector String topic for information about the string syntax for named signals.

The default value is Measurement.

Name

Value

Description

RFMXSPECAN_VAL_DPD_APPLY_DPD_CONFIGURATION_INPUT_MEASUREMENT

0 (0x0)

Uses the computed DPD polynomial or lookup table for applying DPD on an input waveform using the same RFmx session handle. The configuration parameters for applying DPD such as the RFMXSPECAN_ATTR_DPD_DUT_AVERAGE_INPUT_POWER, RFMXSPECAN_ATTR_DPD_MODEL, RFMXSPECAN_ATTR_DPD_MEASUREMENT_SAMPLE_RATE, DPD polynomial, and lookup table are obtained from the DPD measurement configuration.

RFMXSPECAN_VAL_DPD_APPLY_DPD_CONFIGURATION_INPUT_USER

1 (0x1)

Applies DPD by using a computed DPD polynomial or lookup table on an input waveform. You must set the configuration parameters for applying DPD such as the RFMXSPECAN_ATTR_DPD_APPLY_DPD_USER_DUT_AVERAGE_INPUT_POWER, RFMXSPECAN_ATTR_DPD_APPLY_DPD_USER_DPD_MODEL, RFMXSPECAN_ATTR_DPD_APPLY_DPD_USER_MEASUREMENT_SAMPLE_RATE, DPD polynomial, and lookup table. You do not need to call the RFmxSpecAn_Initiate function when you set the DPD Apply DPD Config Input attribute User.