Analyze2

Performs the enabled measurements on the I/Q complex waveform that you specify in IQ parameter. Call this function after you configure the signal and measurement attributes. You can fetch measurement results using the Fetch functions or result attributes in the attribute node. Use this function only if the RFMXINSTR_ATTR_RECOMMENDED_ACQUISITION_TYPE attribute value is either IQ or IQ or Spectral. When using the Analysis-Only mode in RFmxNR, the RFmx driver ignores the RFmx hardware settings such as reference level and attenuation. The only RF hardware settings that are not ignored are the center frequency and trigger type, since it is needed for spectral measurement traces as well as some measurements such as ModAcc, ACP, and SEM.

Performs the enabled measurements on the I/Q complex waveform that you specify in IQ parameter. Call this function after you configure the signal and measurement attributes. You can fetch measurement results using the Fetch functions or result attributes in the attribute node. Use this function only if the RFMXINSTR_ATTR_RECOMMENDED_ACQUISITION_TYPE attribute value is either IQ or IQ or Spectral. When using the Analysis-Only mode in RFmxNR, the RFmx driver ignores the RFmx hardware settings such as reference level and attenuation. The only RF hardware settings that are not ignored are the center frequency and trigger type, since it is needed for spectral measurement traces as well as some measurements such as ModAcc, ACP, and SEM.

Performs the enabled measurements on the I/Q complex waveform that you specify in Spectrum parameter. Call this function after you configure the signal and measurement attributes. You can fetch measurement results using the Fetch functions or result attributes in the attribute node. Use this function only if the RFMXINSTR_ATTR_RECOMMENDED_ACQUISITION_TYPE attribute value is either Spectral or IQ or Spectral.
When using the Analysis-Only mode in RFmxNR, the RFmx driver ignores the RFmx hardware settings such as reference level and attenuation. The only RF hardware settings that are not ignored are the center frequency and trigger type, since it is needed for spectral measurement traces as well as some measurements such as ModAcc, ACP, and SEM.