Specifies the limits to be used in the measurement for Downlink.

Syntax

RFMXNR_ATTR_SEM_DOWNLINK_MASK_TYPE

Numeric Value

Data Type

Access

Applies To

9470008

int32

Read/Write

N/A

Remarks


You do not need to use a selector string to configure or read this attribute for the default signal instance. Refer to the Selector String topic for information about the string syntax for named signals.

The default value is Standard.

Name

Value

Description

RFMXNR_VAL_SEM_DOWNLINK_MASK_TYPE_STANDARD

0 (0x0)

The measurement selects the offset frequencies and limits for SEM, as defined in Table 6.6.4.2.1-1, Table 6.6.4.2.1-2, Table 6.6.4.2.2.1-1, Table 6.6.4.2.2.1-2, Table 6.6.4.2.2.2-1, Table 6.6.4.2.3-1, Table 6.6.4.2.3-2, and Table 6.6.4.2.4-1 in section 6.6.4 and Table 9.7.4.3.2-1, 9.7.4.3.2-2, 9.7.4.3.3-1 and 9.7.4.3.3-2 in section 9.7.4 of the 3GPP TS 38.104 Specification.
If the band value is set to 46 or 96 or 102 the measurement selects the offset frequencies and limits for SEM as defined in Table 6.6.4.5.5A-1, Table 6.6.4.5.5A-2, Table 6.6.4.5.5A-3, and Table 6.6.4.5.5A-4, in section 6.6.4.5 of the 3GPP TS 38.141-1 Specification.
If the band value is set to NTN bands 254, 255 or 256, the measurement selects the offset frequencies and limits for SEM as defined in Table 6.6.4.2-1 in section 6.6.4 of the 3GPP 38.108 specification.
The offset frequencies in Table 9.7.4.3.2-1, 9.7.4.3.2-2, 9.7.4.3.3-1 and 9.7.4.3.3-2 are relative to the contiguous transmission bandwidth edge. The measurement converts these offset frequencies to make them relative to the subblock edge before applying the masks.
For frequency range 1, the RFMXNR_ATTR_GNODEB_CATEGORY attribute can be set to any of the following values: Wide Area Base Station - Category A, Wide Area Base Station - Category B Option1, Wide Area Base Station - Category B Option2, Local Area Base Station, or Medium Range Base Station. Set the RFMXNR_ATTR_BAND attribute for selecting limits table within a gNodeB category.
For frequency range 2-1 and frequency range 2-2, the gNodeB Category attribute can be set to any of the following values: FR2 Category A or FR2 Category B. Set the Band attribute for selecting limits table.

RFMXNR_VAL_SEM_DOWNLINK_MASK_TYPE_CUSTOM

2 (0x2)

Specifies that limits are applied based on user-defined offset segments.