Component Carrier

Specifies a physical layer cell identity.

Specifies whether a component carrier has one or more resource elements allocated.

Specifies the channel bandwidth of the signal being measured. This value is expressed in Hz.

Specifies the offset of the component carrier from the subblock center frequency that you configure in the RFMXNR_ATTR_CENTER_FREQUENCY attribute. This value is expressed in Hz.

Specifies if a carrier is a NR or an E-UTRA carrier while using dual connectivity (EN-DC) signal.

Specifies the NR test model type when you set the RFMXNR_ATTR_DOWNLINK_CHANNEL_CONFIGURATION_MODE attribute to Test Model. Refer to section 4.9.2 of the 3GPP 38.141 specification for more information regarding test model configurations.

Specifies the duplexing technique of the signal being measured. Refer to section 4.9.2 of 3GPP 38.141 specification for more information regarding test model configurations based on duplex scheme.

Specifies the modulation type to be used with the selected test model. Selecting the modulation type is supported only for test models NR-FR2-TM3.1 and NR-FR2-TM2.

Specifies the number of component carriers configured within a subblock. Set this attribute to 1 for single carrier.

Specifies the rated carrier EIRP output power. This value is expressed in dBm.

Specifies the rated carrier TRP output power. This value is expressed in dBm.

Specifies the reference resource grid size when you set the RFMXNR_ATTR_GRID_SIZE_MODE attribute to Manual.

Specifies the reference resource grid start relative to Reference Point A in terms of resource block offset when you set the RFMXNR_ATTR_REFERENCE_GRID_ALIGNMENT_MODE attribute to Manual. Center of subcarrier 0 in common resource block 0 is considered as Reference Point A.

Specifies the subcarrier spacing of the reference resource grid when you set the RFMXNR_ATTR_REFERENCE_GRID_ALIGNMENT_MODE attribute to Manual. This should be the largest subcarrier spacing used in the component carrier. This value is expressed in Hz.

Specifies the sub-band allocation in the NR-U wideband channel. Sub-band is the set of RBs with approximately 20 MHz bandwidth, where the wideband channel is uniformly divided into an integer number of 20 MHz sub-bands.