RFmxLTE SEM Configure Offset Frequency VI

Selector String specifies a selector string comprising of the signal name, subblock number, and offset number. If you do not specify the signal name, the default signal instance is used.

Example:

"subblock0/offset0"

"signal::sig1/subblock0/offset0"

You can use the RFmxLTE Build Offset String VI to build the selector string.

Instrument Handle In specifies the RFmx session refnum. Instrument Handle In is obtained from the RFmxInstr Initialize NIRFSA VI.

Offset Start Freq specifies the start frequency of an offset segment relative to the carrier channel bandwidth edge (single-carrier) or the subblock aggregated channel bandwidth edge (multi-carrier). This value is expressed in Hz. The default value is 0.

Offset Stop Freq specifies the stop frequency of an offset segment relative to the carrier channel bandwidth edge (single-carrier) or the subblock aggregated channel bandwidth edge (multi-carrier). This value is expressed in Hz. The default value is 1 MHz.

Offset Sideband specifies whether the offset segment is present on one side, or on both sides of the carrier. The default value is Both.

Neg (0)	Configures a lower offset segment to the left of the leftmost carrier.
Pos (1)	Configures an upper offset segment to the right of the rightmost carrier.
Both (2)	Configures both the negative and the positive offset segments.

error in describes error conditions that occur before this node runs. This input provides standard error in functionality.

Instrument Handle Out passes a reference to your RFmx session to the next VI.

error out contains error information. This output provides standard error out functionality.