SEM

Specifies whether to enable the traces to be stored and retrieved after performing the SEM measurement.

Specifies whether the amplitude of the frequency bins, used in measurements, is corrected for external attenuation at the RF center frequency, or at the individual frequency bins. Use the RFmxInstr Configure External Attenuation Table function to configure the external attenuation table.

Specifies the limits to be used in the measurement for downlink. Refer to section 6.6.3 of the 3GPP 36.141 specification for more information about standard-defined mask types.

Specifies whether to enable the SEM measurement.

Specifies the maximum number of threads used for parallelism for the SEM measurement.

Specifies the spectrum emission mask used in the measurement for sidelink. Each mask type refers to a different Network Signalled (NS) value. You must set the mask type to Custom to configure the custom offset masks.

Returns the aggregated channel bandwidth of a configured subblock. This value is expressed in Hz. The aggregated channel bandwidth is the sum of the subblock integration bandwidth and the guard bands on either side of the subblock integration bandwidth.

Returns the integration bandwidth of the subblock. This value is expressed in Hz. Integration bandwidth is the span from the left edge of the leftmost carrier to the right edge of the rightmost carrier within the subblock.

Specifies the spectrum emission mask used in the measurement for uplink. Each mask type refers to a different Network Signalled (NS) value. General CA Class B, CA_NS_04, CA_NC_NS_01, CA_NS_09, and CA_NS_10 refers to the carrier aggregation case. You must set the mask type to Custom to configure the custom offset masks.