Use the VIs on this palette to configure output radio frequency spectrum (ORFS) measurements.

RFmxGSM ORFS Configure Measurement Type VI
Configures the type of spectral distortion to be measured.
RFmxGSM ORFS Configure Averaging VI
Configures averaging for the output radio frequency spectrum (ORFS) measurement.
RFmxGSM ORFS Configure Offset Frequency Mode VI
Configures the list of frequency offsets for which you can perform the output radio frequency spectrum (ORFS) measurements.
RFmxGSM ORFS Configure Evaluation Symbols VI
Configures the evaluation symbols. The GSM standard specifies that 50% to 90% portion of the burst, excluding the midamble, be measured. However, RFmxGSM allows you to specify the portion of the burst to measure for ORFS due to modulation. RFmx considers the measurement over evaluation symbols for a single burst as one average.
RFmxGSM ORFS Configure Noise Compensation Enabled VI
Configures whether to enable compensation of the channel powers for the inherent noise floor of the signal analyzer.
RFmxGSM ORFS Configure Modulation Custom Offset Frequency (Array) VI
Configures an array of positive offset frequencies relative to the carrier frequency for the spectrum measurement because of modulation when you set the ORFS Offset Freq Mode property to Custom.
RFmxGSM ORFS Configure Switching Custom Offset Frequency (Array) VI
Configures an array of positive offset frequencies relative to the carrier frequency for the spectrum measurement because of switching when you set the ORFS Offset Freq Mode property to Custom.

Parent topic: Configuration

RFmx GSM LabVIEW Reference

Log in to get a better experience