Specifies the region to exclude for computing the individual slot phase discontinuity values. This value is expressed in seconds.

The transient duration is applied equally on either side of a slot boundary, that is at the start and end of each slot. If you set the transient duration to zero, there is no transient period and the entire slot data is used to determine the phase error best fit line which is used to compute the phase discontinuity at the slot boundaries.

You do not need to use a selector string to configure or read this property for the default signal instance. Refer to the Selector Strings topic for information about the string syntax for named signals.

The default value is 0. The valid values are 0 to 0.0002, inclusive.

Remarks

The following table lists the characteristics of this property.

Short Name SlotPhase Transient Duration (s)
Data type cdbl.png
Permissions Read/Write
High-level VIs N/A
Resettable Yes