SEM

Configures the number of carriers for the spectral emission mask (SEM) measurement.

Configures whether to consider the carrier power as part of total carrier power measurement.

Use "carrier<n>" as the selector string to configure this VI.

Configures the center frequency, in Hz, of the carrier, relative to the RF center frequency.

Use "carrier<n>" as the selector string to configure this VI.

Configures the frequency range, in Hz, over which the measurement integrates the carrier power.

Use "carrier<n>" as the selector string to configure this VI.

Configures the resolution bandwidth (RBW) filter of the carrier signal.

Use "carrier<n>" as the selector string to configure this VI.

Configures the root raised cosine (RRC) channel filter to apply on the acquired carrier channel before measuring the channel power. RRC alpha is the filter roll off.

Use "carrier<n>" as the selector string to configure this VI.

Configures the channel bandwidth of the carrier.

Use "carrier<n>" as the selector string to configure this VI.

Configures the number of offset segments for the spectral emission mask (SEM) measurement.

Configures the offset frequency start and stop values and specifies whether the offset segment is present on one side, or on both sides of the carriers.

Use "offset<n>" as the selector string to configure this VI.

Configures the resolution bandwidth (RBW) filter of the offset segment.

Use "offset<n>" as the selector string to configure this VI.

Configures the resolution of the spectrum to compare with spectral mask limits as an integer multiple of the resolution bandwidth (RBW).

Use "offset<n>" as the selector string to configure this VI.

Configures the attenuation, in dB, relative to the external attenuation.

Use "offset<n>" as the selector string to configure this VI.

Specifies the criteria to determine the measurement fail status.

Use "offset<n>" as the selector string to configure this VI.

Configures the absolute limit mode and specifies the absolute power limits corresponding to the beginning and end of the offset segment.

Use "offset<n>" as the selector string to configure this VI.

Configures the relative limit mode and specifies the relative power limits corresponding to the beginning and end of the offset segment.

Use "offset<n>" as the selector string to configure this VI.

Configures the offset frequency definition for the SEM measurement.

Use "offset<n>" as the selector string to configure this VI.

Configures the units for the absolute power.

Configures whether the power reference is the integrated power or the peak power in the closest carrier channel.

Configures the sweep time.

Configures averaging for the spectral emission mask (SEM) measurement.

Configures window and FFT to obtain a spectrum for the spectral emission mask (SEM) measurement.

Creates the carrier string to use as the selector string with the SEM, ACP, and CHP carrier configuration or fetch properties and VIs.

Creates the offset string to use as the selector string with SEM and ACP offset configuration or fetch properties and VIs.

Use the VIs on this palette to configure spectral emission mask (SEM) measurements. You can use the RFmxSpecAn Property Node to configure additional properties.