Removing Bus Connectors

Complete the following steps to remove bus connectors from the DIN rail.

What to Use

  • Flathead Screwdriver

What to Do

Note You must remove the preceding module before removing the bus connector.

1378

  1. Slide the bus connector away from the preceding bus connector at least 5.0 mm (0.20 in.).
  2. Insert the screwdriver and loosen both latches on one side of the DIN rail.
  3. Rotate the bus connector to remove it from the DIN rail.
    Note If you want to remove a bus connector in the middle of the system, you must remove any modules or bus connectors following the desired connector or slide them along the DIN rail at least 15.0 mm (0.60 in.).