Installing the Hot Pluggable QSFP+ Module

  1. Hold the QSFP+ module with the pull-tab facing the left.
  2. Remove the protective cover from the opposite end of the pull-tab. Leave the dust plug inserted in the pull-tab end.
    Figure 6. QSFP+ Module Install

    1378

  3. With the pull-tab facing the left, align the QSFP+ module with the socket opening at PORT 0 on the PXIe-7899. Carefully slide the QSFP+ module into PORT 0.
  4. Use your thumb to press firmly on the QSFP+ module until it fully seats into PORT 0.
    Note The QSFP+ module must be fully seated in PORT 0 for the PXIe-7899 to detect a connection. To test the QSFP+ module presence at PORT 0, refer to What Should I Do if the Cannot Communicate with XC Devices?.
  5. Power on the chassis.
To protect the QSFP+ module from dust and debris, NI recommends leaving the dust plug inserted in the pull-tab end of the module until you are ready to connect a cable.