Power On and Reset Conditions

The PXIe-5673/5673E hardware is in the following state after powering on or restarting the system and allowing the PC operating system and NI-RFSG to fully load. These conditions are also true after a device reset that you perform directly from NI Measurement & Automation Explorer (MAX).
  • PXIe-5611 I/Q modulator module is powered on.
  • All module front panel ACCESS LEDs are green.
  • LO OUT front panel connector is disabled.
  • All attenuators are asserted.
  • All module front panel ACTIVE LEDs are off.
  • RF output power is set to <-140 dBm, minimum.
  • Warmup begins (if applicable).