PRFMsc Configure Calibration Method

Download PDF

Sets the calibration method to use for the S-parameter measurement.

S-Par Reference In

Specifies the session reference handle of the S-parameter measurement session.

Specifies the supported calibration method based on the measurement topology. The default value is None.

SOL	Specifies that SOL calibration is performed. This calibration is appropriate for the S11, 1 Coupler measurement topology and the S11, 2 Couplers measurement topology.
SOLT	Specifies that SOLT calibration is performed. This calibration is appropriate for the 1 Coupler per Port, 1 VST measurement topology or the 1 Coupler Per Port, 2 VSTs measurement topology.
SOLR	Specifies that SOLR calibration is performed. This calibration is appropriate for the 2 Couplersper Port, 1 VST measurement topology.
QSOLT	Specifies that QSOLT calibration is performed. This calibration is appropriate for the 2 Couplers per Port, 1 VST measurement topology.
Through	Specifies that through calibration is performed. This calibration is appropriate for S21 only S-parameter measurements.
TRL	Specifies that TRL calibration is performed. This calibration is appropriate for 2 Couplers per Port,1 VST with Solid State Switch measurement topology.
None	Specifies not to perform calibration. This method is valid for all measurements. When you specify this method, results are calculated based on raw measurements.

Error conditions that occur before this node runs. This input provides standard error in functionality.

Returns the session reference handle of the S-parameter measurement session.

Error information. This output provides standard error out functionality.