Measurements Group

In the group of type Measurements, the area Header data is completely pre-parameterized. Nevertheless, it must be adjusted to the corresponding task. You can also specify which recording frequencies are to be used. Settings have to be made in the following columns.

Settings have to be made in area Detail data.

Figure 84. Measurement Files

1378

Adjust the columns as follows:

Extension Column

The file extension can be entered if the selected file type does not give it by default. In order to make automatic file change possible this column must contain a "%C" (e.g., "%C.erg").

The following table shows which file types already have an extension or where to make settings if desired.

Data type Extension Recommendation for Extension
PAtools ASCII — .erg
EDAS32 — .edas32
Diadem 32Bit .r32 or .dat —
Uniplot .nc —
Diadem 64Bit .r64 or .dat —
PAtools Binary — .bin
MDF4 .mf4 —
Famos — .raw
CSV — .csv

File Type Column

Here you can select in which file format the data will be recorded. A mixture of different file types is possible, but not for the same frequency (operation) group. If this is desired a new measurement has to be used.

Storage Type Column

In this column, you can select the storage type and the type of recording. The variants cyclic, buffered, and measuring point are available here.