RfsgArb.ReadAndDownloadWaveformFromFileTdms Method

public void ReadAndDownloadWaveformFromFileTdms(
	string waveformName,
	string filePath,
	uint waveformIndex
)

Public Sub ReadAndDownloadWaveformFromFileTdms ( 
	waveformName As String,
	filePath As String,
	waveformIndex As UInteger
)

Parameters

waveformName  String

Specifies the name used to store the waveform. This string is case-insensitive.

filePath  String

Specifies the absolute path to the TDMS file from which the NI-RFSG reads the waveforms.

waveformIndex  UInt32

Specifies the index of the waveform to be read from the TDMS file.

This method reads the following information from the TDMS file and writes it into the NI-RFSG session:

Sample Rate

PAPR

Runtime Scaling

RF Blanking

Marker Locations

RF Blanking Enabled

Burst Start Locations

Burst Stop Locations

RF Blanking Marker Source

Signal Bandwidth

Waveform Size

If RF blanking marker locations are present in the file but burst locations are not present, burst locations are calculated from RF blanking marker locations and stored in the NI-RFSG session.

Reference