NIRfsg Namespace

Table of Contents

RfsgRF Properties

  • Updated2025-05-22
  • 3 minute(s) read
RfsgRF Properties

RfsgRF Properties

The RfsgRF type exposes the following members.

Properties

 NameDescription
Public propertyAdvanced Gets the Advanced sub-object that relate only to the RF Advanced.
Public propertyExternalGain Gets or sets the external amplification or attenuation, if any, between the RF signal generator and the device under test.
Public propertyFrequency Gets or sets the frequency of the generated RF signal, in Hertz (Hz). For arbitrary waveform generation, this property specifies the center frequency of the signal.
Public propertyLocalOscillator Gets the LocalOscillator sub-object that relate only to the local oscillator. An active channel can be passed using the indexer ItemString.
Public propertyLOOutExportConfigureFromRfsa Specifies whether to allow NI-RFSA to control the NI-RFSG LO out export.
Public propertyOutputEnabled Gets or sets whether signal output is enabled or disabled.
Public propertyPeakPowerAdjustment Gets or sets the adjustment for PowerLevel.
Public propertyPhaseOffset Gets or sets the phase, in degrees (º) of the RF output signal.
Public propertyPowerLevel Gets or sets either the average power level or peak power level of the generated RF signal, depending on PowerLevelType setting.
Public propertyPowerLevelType Gets or sets the way the driver interprets the value of PowerLevel.
Public propertyRFBlankingSource Gets or sets the Marker event at which RF blanking occurs.
For PXIe-5830/5831/5832, the RF Blanking reserves a PXI trigger line. If you are calling any RfsgDriverUtility.ResetDevice or RfsaDriverUtility.ResetDevice on the same device, NI recommends calling it before committing blanking attributes. Alternatively, you can call RfsgDriverUtility.ResetWithOptions or RfsaDriverUtility.ResetWithOptions. Select Routes in the stepsToOmit parameter.
Public propertyRFInLOExportEnabled Specifies whether to enable the RF IN LO OUT terminal on the PXIe-5840.
Public propertyUpconverter Gets the Upconverter sub-object that relate only to the RF upconverter.
Public propertyWaveforms Gets the RfsgRFWaveformCollection sub-object used to configure channel based waveform attributes.
Top

See Also

Log in to get a better experience