NIVNA_ATTR_AUTOCAL_BOX_ORIENTATION
- Updated2023-02-21
- 1 minute(s) read
Specific Attribute
| Data type |
Access | Applies to | Coercion | High Level Functions |
|---|---|---|---|---|
| ViInt32 | R/W | Channel | None | None |
Description
Specifies the orientation of the AutoCal module. If you set this attribute incorrectly, the AutoCal assurance fails. Enable AutoCal assurance using the NIVNA_ATTR_AUTOCAL_ASSURANCE_ENABLED attribute.
Defined Values:
| NIVNA_VAL_AUTOCAL_BOX_ORIENTATION_A (1) |
Specifies that either the VNA PORT 1 connects to the left port on the AutoCal module or PORT 2 connects to the right port on the AutoCal module, as indicated in the following table. An X indicates that the specified port is not applicable.
|
||||||||||||
| NIVNA_VAL_AUTOCAL_BOX_ORIENTATION_B (0) |
Specifies that either the VNA PORT 1 connects to the right port on the AutoCal module or PORT 2 connects to the left port on the AutoCal module, as indicated in the following table. An X indicates that the specified port is not applicable.
|
||||||||||||
| NIVNA_VAL_AUTOCAL_BOX_ORIENTATION_AUTO_SENSE (2) |
Specifies that the VNA determines the orientation of the AutoCal module. The supported calibration is two-port SOLT. |
Supported Devices: NI 5630/5632