Configuration:Bandwidth Property

Short Name: Bandwidth

Property of niUSRP

Specifies the bandwidth, in Hz, of the analog filter used in the RF front-end.

This property sets an upper limit to the maximum bandwidth that the device can acquire or generate. Refer to your device specifications for more information about available bandwidth options.

The range of available values is hardware dependent. If you specify a value outside the range supported by your device, NI-USRP coerces the value to the nearest supported value. Writing to this property specifies the value you want to use. Reading from this property returns the actual value, which may have been coerced to the capabilities of the device. NI recommends that you read the value after you write to this property to determine the actual setting for the device.

Remarks

The following table lists the characteristics of this property.

Datatype
Permissions	Read/Write
High-level VIs	niUSRP Configure Signal
Channel-based	Yes
Resettable	Yes