SwitchCharacteristics Properties
- Updated2023-02-21
- 3 minute(s) read
The SwitchCharacteristics type exposes the following members.
| Name | Description | |
|---|---|---|
 | ACCurrentCarryMax | Gets the maximum AC current that the channel can carry. |
| ACCurrentSwitchingMax | Gets the maximum AC current that the channel can switch. |
| ACPowerCarryMax | Gets the maximum AC power that the channel can carry. |
| ACPowerSwitchingMax | Gets the maximum AC power the channel can switch. |
| ACVoltageMax | Gets the maximum AC voltage the channel can switch. |
| Bandwidth | Gets the bandwidth for the channel. |
| DCCurrentCarryMax | Gets the maximum DC current the channel can carry. |
| DCCurrentSwitchingMax | Gets the maximum DC current that the channel can switch. |
| DCPowerCarryMax | Gets the maximum DC power that the channel can carry. |
| DCPowerSwitchingMax | Gets the maximum DC power that the channel can switch. |
| DCVoltageMax | Gets the maximum DC voltage the channel can switch. |
| Impedance | Gets the characteristic impedance for the channel. |
| SettlingTime | Gets or sets the maximum length of time from after you make a connection until the signal flowing through the channel settles. The units are seconds. NOTE: If you use PXI-2501/2503/2565/2590/2591 the actual delay will always be the greater value of the SwitchCharacteristics.SettlingTime and the value you specify as the SwitchScan.Delay. |
| WireMode | Gets the wire mode of the switch device. This property affects the values of the SwitchModuleCharacteristics.NumberOfRows and SwitchModuleCharacteristics.NumberOfColumns attributes. The actual number of input and output lines on the switch device is fixed, but the number of channels depends on how many lines constitute each channel. |