ScopeChannel Properties

Gets or sets whether the bandpass filter is enabled on the specified channel.

Gets or sets the CableSense Signal Mode

Gets the CableSense signal voltage amplitude for the given channel

Gets or sets how the digitizer couples the input signal for the channel. When input coupling changes, the input stage takes a finite amount of time to settle.

Gets or sets the gain on the specified channel in hardware before any onboard signal processing occurs.

Gets or sets the offset on the specified channel in hardware before any onboard signal processing occurs.

Gets or sets whether dither is enabled on the channel.

Gets or sets whether the digitizer acquires a waveform for the channel.

Gets or sets a value specifying whether to enable the interleaving offset correction.

Gets or sets the instrument to use multiple ADCs to sample the same waveform at a higher effective real-time sample rate.

Gets or sets the type of filter needed to achieve desired filtering characteristics.

Gets or sets the frequency for the highpass filter in Hz.

Gets or sets the bandwidth, in hertz, of the channel. Express this value as the frequency at which the input circuitry attenuates the input signal by 3 dB.

Gets or sets the input impedance, in ohms, for the channel.

Gets the ScopeChannelMeasurement sub-object that is related to configuring digitizers to obtain scalar and array measurements.

Gets the name of the channel.

Gets or sets the location of the center of the range with respect to ground in volts.

Gets the ScopeChannelOnboardSignalProcessing sub-object that is related to configuring the onboard signal processing (OSP) block of the high speed digitizer.

Gets or sets the probe attenuation for the input channel. For example, for a 10:1 probe, set this property to 10.0.

Gets or sets the absolute value, in volts, of the input range for a channel. For example, to acquire a sine wave that spans between -5 and +5 V, set this property to 10.0 V.

Gets or sets the terminal configuration for the channel.