RfsgRF Properties
- Updated2024-05-08
- 3 minute(s) read
RfsgRF Properties
The RfsgRF type exposes the following members.
Properties
| Name | Description | |||
|---|---|---|---|---|
 | Advanced |
Gets the Advanced sub-object that relate only to the RF Advanced.
| ||
| ExternalGain |
Gets or sets the external amplification or attenuation, if any, between the RF signal generator and the device under test.
| ||
| Frequency |
Gets or sets the frequency of the generated RF signal, in Hertz (Hz). For arbitrary waveform generation, this property specifies the center frequency of the signal.
| ||
| LocalOscillator |
Gets the LocalOscillator sub-object that relate only to the local oscillator. An active channel can be passed using the indexer ItemString.
| ||
| LOOutExportConfigureFromRfsa |
Specifies whether to allow NI-RFSA to control the NI-RFSG LO out export.
| ||
| OutputEnabled |
Gets or sets whether signal output is enabled or disabled.
| ||
| PeakPowerAdjustment |
Gets or sets the adjustment for PowerLevel.
| ||
| PhaseOffset |
Gets or sets the phase, in degrees (º) of the RF output signal.
| ||
| PowerLevel |
Gets or sets either the average power level or peak power level of the generated RF signal, depending on PowerLevelType setting.
| ||
| PowerLevelType |
Gets or sets the way the driver interprets the value of PowerLevel.
| ||
| RFBlankingSource |
Gets or sets the Marker event at which RF blanking occurs.
| ||
| RFInLOExportEnabled |
Specifies whether to enable the RF IN LO OUT terminal on the PXIe-5840.
| ||
| Upconverter |
Gets the Upconverter sub-object that relate only to the RF upconverter.
| ||
| Waveforms |
Gets the RfsgRFWaveformCollection sub-object used to configure channel based waveform attributes.
|
Note