Configures the trigger that synchronizes the RF measurement with the RF pulse generation.

Configure RFSG to RFmx Trigger (Automatic Routing) (Pulse) VI
Configures the pulse trigger used for the synchronization. When the RF mode is Pulsed CW, this method uses dynamic routing to set the RFSG Pulse Trigger Output as the input to the RFmx Trigger using an available PXI backplane trigger line. When the RF mode is CW, this method does not export the RFSG Pulse Trigger or configure a RFmx Trigger. In Pulsed CW mode, RFSG exports the pulse trigger at the start of each pulse. In CW RF mode, no trigger is exported and this setting is ignored. RFmx waits for the measure trigger before taking each measurement.
Configure RFSG to RFmx Trigger (Manual Routing) (Pulse) VI
Configures the trigger that synchronizes the RF measurement with the RF pulse generation. A pulse trigger is used for the synchronization. In pulsed CW RF mode RFSG exports the pulse trigger at the start of each pulse. In CW RF mode, no pulse trigger is exported and this setting is ignored.
Configure RFSG to RFmx Trigger (Manual Routing) (Gate) VI
Configures the trigger that synchronizes the RF measurement with the RF pulse generation. RFSG exports a gate trigger around the RF pulse. The gate starts the RFSG pre-trigger time before the RF pulse, and the gate ends the RFSG post-trigger time after the pulse. RFmx only responds to a pulse trigger, so the RFmx reference trigger corresponds to the rising edge of the gate.

Parent topic: Configuration

Power-Added Efficiency Measurement Library LabVIEW VI Reference

Log in to get a better experience