Math Channel

You can configure the mathematical channel to perform mathematical operations on the signal.

Use the following settings to configure the math channel.

Setting Description
Status 1378 Enables or disables math operation on the source channels.
Volts/div Vertical scale of the display.
Shrink 1378 Contracts the trace by increasing Volts/div.
Expand 1378 Expands the trace by decreasing Volts/div.
Vertical position Vertical positioning of the waveform on the graph. Use Vertical position to move the waveform up and down the graph. The Oscilloscope does not apply Vertical position to the input signal. The range of Vertical position is -100 V to 100 V.
Function Math operation you want to perform on the channels.
Source A First source channel.
Source B Second source channel.

Digital Filtering

The Oscilloscope may acquire noisy signals. Use digital filtering to remove unwanted parts of the captured waveform such as noise within the bandwidth of the instrument. You can set Function to Filter to enable digital filtering. Use the following settings to configure the math channel when digital filtering is enabled:

Setting Description
Source Source channel on which you want to perform digital filtering.
Typology The design type of the filter.
  • Butterworth filter—Rolls off slowly around the cutoff frequency.
  • Chebyshev filter—Rolls off moderately around the cutoff frequency.
Type The passband of the filter. Only low pass filter is available.
Order The maximum delay, in samples, used in creating each output sample. The range of Order is between 1 and 16.
Cutoff frequency A frequency characterizing a boundary between a passband and a stopband. The value of Cutoff frequency must be greater than 0.