Multi Point Acquisition:Sample Delay Mode Property
- Updated2023-02-21
- 1 minute(s) read
Short Name: Sample Delay Mode
Property of niDMM
Specifies when the Sample Interval property is used. Set this property before calling niDMM Configure Multi Point if you configure the properties for multipoint measurements using the niDMM Configure Multi Point VI.
 |
Note The NI 4080/4081/4082 are not supported. |
| 0 | IVI compliant | The Sample Interval property is only used when the Sample Trigger is set to Interval. |
| 1 | Not IVI compliant | The Sample Interval property is used as a delay after any type of Sample Trigger. |
Remarks
The following table lists the characteristics of this property.
| Datatype |  |
| Permissions | Read/Write |
| High-level VIs | N/A |
| Resettable | No |