DigitalLevels Properties
- Updated2023-11-24
- 3 minute(s) read
DigitalLevels Properties
The DigitalLevels type exposes the following members.
Properties
| Name | Description | |
|---|---|---|
 | Ioh |
Gets or sets the current that the DUT sources to the active load while outputting a voltage above Vcom.
|
| Iol |
Gets or sets the current that the DUT sinks from the active load while outputting a voltage below Vcom.
|
| TerminationMode |
Gets or sets the behavior of the pin when pin driver is in a non-drive cycle.
|
| Vcom |
Gets or sets the commutating voltage at which the active load circuit switches between between sourcing current and sinking current.
|
| Vih |
Gets or sets the input voltage that the digital pattern instrument applies to the input of the DUT when the test instrument drives a logic high (1).
|
| Vil |
Gets or sets the input voltage that the digital pattern instrument applies to the input of the DUT when the test instrument drives a logic low (0).
|
| Voh |
Gets or sets the output voltage from the DUT above which the comparator on the test instrument interprets a logic high (H).
|
| Vol |
Gets or sets the output voltage from the DUT below which the comparator on the test instrument interprets a logic low (L).
|
| Vterm |
Gets or sets the termination voltage the instrument applies during non-drive cycles when the TerminationMode is set to
Vterm. The instrument applies the termination voltage through a 50 Ω parallel termination resistance.
|