Compares the array in requested outputs to the array in measured outputs and calculates the calibration constants for the output resistance of the specified channel. Refer to the calibration procedure for the device you are calibrating for detailed instructions on the appropriate use of this VI. This VI can only be called from an external calibration session.

Note NI-DCPower uses the terms "source" and "output". However, while sinking with electronic loads and SMUs these correspond to "sinking" and "input", respectively.
Note This VI is not supported by all devices. Refer to Supported VIs by Device for information about supported devices.


icon

Inputs/Outputs

  • civrn.png instrument handle —

    instrument handle identifies a particular instrument calibration session. instrument handle is obtained from the niDCPower Initialize External Calibration VI.

  • cstr.png channel name —

    channel name specifies the channel to which these calibration settings apply. Only one channel at a time can be calibrated.

  • cu32.png number of measurements —

    number of measurements specifies the number of elements in requested outputs and measured outputs.

  • cerrcodeclst.png error in (no error) —

    error in describes error conditions that occur before this node runs. This input provides standard error in functionality.

  • c1ddbl.png requested outputs —

    requested outputs specifies an array of the output values requested in the niDCPower Configure Current Limit VI.

  • c1ddbl.png measured outputs —

    measured outputs specifies an array of the output values measured by an external precision digital multimeter.

  • iivrn.png instrument handle out —

    instrument handle out passes the handle used to identify the session in all subsequent NI-DCPower VI calls.

  • ierrcodeclst.png error out —

    error out contains error information. This output provides standard error out functionality.