DCPowerOutputSourcePulseCurrent.BiasVoltageLimit Property
- Updated2024-01-04
- 2 minute(s) read
DCPowerOutputSourcePulseCurrentBiasVoltageLimit Property
Gets or sets the pulse voltage limit, in volts, that the output cannot exceed when generating the desired current on the specified channel(s) during the off phase of a pulse.
Namespace: NationalInstruments.ModularInstruments.NIDCPower
Assembly: NationalInstruments.ModularInstruments.NIDCPower.Fx40 (in NationalInstruments.ModularInstruments.NIDCPower.Fx40.dll) Version: 2023
Syntax
public double BiasVoltageLimit { get; set; }
Public Property BiasVoltageLimit As Double Get Set
Property Value
Type: DoubleThe valid values for this property are defined by the values you specify for the VoltageLimitRange property.
Remarks
This property is applicable only if the DCPowerSourceOutputFunction property is set to PulseCurrent
and the DCPowerComplianceLimitSymmetry property is set to Symmetric.
 Note |
|---|
| A channel must be enabled for the specified bias voltage limit to take effect. Refer to the Enabled property for more information about enabling the output channel. |
| Note |
|---|
| NI-DCPower uses the terms "source" and "output". However, while sinking with electronic loads and SMUs these correspond to "sinking" and "input", respectively. |
| Note |
|---|
| This property is not supported by all instruments. Refer to the Supported Properties by Device topic in the NI DC Power Supplies and SMUs Help for information about supported instruments. |