DAQmx Setup 11637 Calibration VI

calhandle in is a reference to the calibration session that you created using the DAQmx Initialize External Calibration VI.

physical channels specifies the name of the physical channel to use. The DAQmx physical channel constant lists all physical channels on devices and modules installed in the system.

You also can wire a string that contains a physical channel to this input. You cannot specify more than one physical channel.

bridge config specifies the Wheatstone bridge configuration connected to the channel.

excitationValue specifies in volts the amount of excitation supplied to the sensor. Refer to the sensor documentation to determine appropriate excitation values.

error in describes error conditions that occur before this VI or function runs.

The default is no error. If an error occurred before this VI or function runs, the VI or function passes the error in value to error out. If an error occurs while this VI or function runs, the VI or function runs normally and sets its own error status in error out. Use the Simple Error Handler or General Error Handler VIs to display the description of the error code. Use error in and error out to check errors and to specify execution order by wiring error out from one node to error in of the next node.

calhandle out is a reference to the calibration session. Wire this output to other external calibration VIs.

error out contains error information. If error in indicates that an error occurred before this VI or function ran, error out contains the same error information. Otherwise, error out describes the error status that this VI or function produces.

Right-click the error out indicator on the front panel and select Explain Error from the shortcut menu for more information about the error.