Generation Configuration

Configures the number of samples in a finite operation or configures the device to continuously acquire (if ni5640R session is an acquisition session) or generate (if ni5640R session is a generation session) samples.

Configures the IQ carrier frequency of the IF signal for the acquisition session (if ni5640R session is an acquisition session) or the generation session (if ni5640R session is a generation session) you pass to this VI.

Configures the rate at which the device samples IQ values. The digital filter passband is 0.4 multiplied by the IQ rate. The IQ rate is coerced to the next highest value that the device is capable of.

Note  Any frequency content should be at most 0.4 times the actual IQ rate. When generating, having any signal higher than 0.4 times the actual IQ rate could cause aliasing or numerical overflows.

Specifies which channels are enabled or disabled for the acquisition session (if ni5640R session is an acquisition session) or the generation session (if ni5640R session is a generation session) you pass to this VI. You must call this VI prior to beginning an acquisition or generation.

Configures the device for streaming generation.

Configures the desired power level. Note: Power level adjustments are made using a digital multiplier. The digital multiplier may cause quantization effects as well as a reduction in signal-to-noise ratio. If the magnitude of the written waveform data, √(I² + Q²), is greater than 1, the signal could be clipped.

Configures the Reference clock.

Use the Trigger VIs to configure the triggers you use for your operation.

Use the Actual Values VIs to query the coerced value of properties such as IQ rate.