Removing the Charger Cable Connected to the RMX-41011

Learn how to remove and replace the charger cable (part number 139376-1R5) on the RMX-41011.

Equipment

  • #2 Phillips screwdriver
  • NI screwdriver
  • Tray for loose fastening hardware
Note The charger cable replacement instructions only refer to the replacement of the 139376-1R5 cable. Other cables or spare parts might have different requirements.
  1. Follow all Before Maintenance or Repair procedures.
  2. While facing the mass interconnect, remove the right-side panel of the rack.
    1. Unlatch the eight captured quarter-turn screws.
    2. Retract the pull latches.
    3. Set aside the side panel.
    Note To avoid damage to the panel, keep the panel upright. Do not load the panel mid-span.
  3. While facing the human-machine interface (HMI) side of the rack, remove the 8U filler panel above the keyboard.
  4. Remove the wire from the connector.
    Note Leave the charge connector connected to the RM-16061.
  5. When facing the mass interconnect side of the rack, unlock and open the top door of the rack.
  6. Remove the cover on the RMX-41011.
  7. Unscrew the ring lugs on the RMX-41011.
  8. Locate and remove the charger cable.
    The cable is routed under the RM-16061, between the RMX-41011 and RM-16061.

Replacing the Charger Cable on the RMX-41011

  1. Install the system-level cable labels on the charger cable.
  2. Route the new charger cable under the RM-16061, between the RMX-41011 and RM-16061.
  3. Screw the ring lugs into the RMX-41011 and replace the covers.
  4. Push the ferrules into the charger cable connector.
  5. Close the rack.