DIAdem Help

Scale

  • Updated2024-09-12
  • 2 minute(s) read

Scale

Use this dialog box to scale channels.

Settings

Channel Specifies the channel to be scaled.
Factor Specifies the factor DIAdem uses to multiply the channel that is to be scaled.
Offset Specifies the offset that DIAdem adds to the channel that is to be scaled.
Store result in original channel Overwrites the values of the input channels. Do not select this setting if you want to use the input channels again.
If you want to use waveform channels in this dialog box, follow Rule 2.3 for Calculating with Waveform Channels.

Result

DIAdem generates a result channel with the scaled single values of the original channel.

Note  Specify the Factor -1 and the Offset 0 to invert the signs of the channel values, for example, to invert the polarity of a signal.
To calculate quantity-based in DIAdem, click the Calculate Quantity-Based button on the DIAdem ANALYSIS toolbar. When executing quantity-based calculations, DIAdem checks whether the program can also execute calculations on physical quantities in the same calculation. If DIAdem cannot execute the calculation because the physical quantities are unsuitable, the program displays an error message. Refer to the Help page Calculating Quantity-Based and Non-Quantity-Based in DIAdem for the conditions and rules for quantity-based calculations.

Script Call

Call SUDDlgShow("Main", ResourceDrv & "AnaChnLinScale")

ChnLinScale

Log in to get a better experience