Supported Hardware for NI-Embedded CAN for RIO

Overview

This document lists all supported hardware for NI-Embedded CAN for RIO.

The NI-Embedded CAN for RIO software supports the following NI hardware products:

  • Onboard CAN interfaces of Single-Board RIO-9605/9606 — NI-RIO 4.0 or later and LabVIEW 2011 or later required.

         NI sbRIO-9605
         NI sbRIO-9606

The NI-Embedded CAN for RIO software supports a partial list of the Single-Board RIO hardware. Refer to Software Support for CompactRIO, CompactDAQ, Single-Board RIO, R Series, and EtherCAT for information about software support.

Was this information helpful?

Yes

No