Archived: USB NI 63xx X Series Bugs Fixed in NI-DAQmx 9.3
Updated Mar 17, 2020
NI does not actively maintain this document.
This content provides support for older products and technology, so you may notice outdated links or obsolete information about operating systems or other relevant products.
NI has recommended that all USB X Series customers upgrade to DAQmx 9.3 if they are using an earlier version of the driver. This document lists the specific bugs that were fixed in DAQmx 9.3 that prompted this recommendation.
NI-DAQmx 9.3 contains bug fixes for the following issues present on X Series devices (NI USB-63xx) when used with earlier versions of the driver. If you believe any of these issues have the possibility of affecting your application, NI recommends that you upgrade to NI-DAQmx 9.3.
Digital I/O Glitches on Computer Restart
In NI-DAQmx 9.2.3 and earlier, if a USB X Series device remains powered during a computer restart, the digital lines will glitch high for approximately 1-2 seconds before loading programmable power-up states. This behavior only occurs on lines that were previously being driven low at the time of the the computer restart. If a line was being driven high or configured as an input (i.e. tri-state) at the time of the restart, then the glitch would not occur.
Starting with NI-DAQmx 9.3, the digital lines retain their original value until the programmable power-up states are loaded.
Digital I/O Returns/Generates 0 in Some Cases:
In DAQmx 9.2.3 and earlier, USB X Series devices with 32 digital I/O lines on port 0 (NI USB-6343, NI USB-6353, and NI USB-6363) may return or generate 0 lines if either of the following cases are met:
A Digital Input or Output task contains 8 or fewer lines and does not include any of lines 0:7
A Digital Input or Output task contains 16 or fewer lines and does not include any of lines 0:15
The behavior may be worked around by including the lines mentioned above, but has been corrected for in NI-DAQmx 9.3.
Analog Input Channels Swap in Some Cases (Multiplexed Boards Only)
In DAQmx 9.2.3 and earlier, multiplexed USB X Series devices may return data from the incorrect channels if the following events occur sequentially:
A multi-channel analog input task is explicitly committed. An example use-case of
committing a task can be found here.
The task is started.
The task is stopped before it has finished its acquisition.
The task is restarted.
If the device is in the middle of converting samples when it is stopped (step 3 above), then upon restart DAQmx will return data from the incorrect channels.
Encountering this issue should be very rare given that there are not any obvious use-cases for performing the above steps as described. The behavior is corrected in NI-DAQmx 9.3.
Unser Look hat sich geändert, unsere Devise bleibt gleich: Im Mittelpunkt steht der Kunde. Damit Sie selbst die komplexesten Herausforderungen der Zukunft mit Zuversicht annehmen können, haben wir unser Angebot erweitert. Sind Sie bereit? Let's Engineer Ambitiously.