Each issue appears as a row in the table and includes the following fields:
- Issue ID - The number in at the top of each of the cells in the first column. When you report an issue to NI, you may be given this ID, you can also find IDs posted by NI on the discussion forums or in Knowledge Base articles. "N/A" indicates that there is no ID assigned to the issue.
- Issue Title (in italics) - Describes the issue in one sentence or less.
- Problem Description - A few sentences which describe the problem in further detail. The brief description given does not necessarily describe the problem in full detail, and it is expected that you may want more information on an issue. If you would like more information on an issue, contact NI and reference the ID number given in the document.
- Workaround - Possible ways to work around the problem. The workarounds that appear in the document are not always tested by NI and are not guaranteed to resolve the issue. If a workaround refers you to the NI KnowledgeBase, visit www.ni.com/kb/ and enter the KnowledgeBase number in the search field to locate the specific document.
- Reported Version - The earliest version of NI-RFSG in which the issue was reported. If you discover the issue appears in an earlier version of NI-RFSG than is reported in this field, report the discrepancy to NI to have the field updated.
- Resolved Version - Version in which the issue was resolved or was no longer applicable. "N/A" indicates that the issue has not been resolved.
- Date Added - The date the issue was added to the document (not the reported date).
Known Issues by Severity
||The None filter for FFT window type does not provide expected results for spectral measurements
When the FFT window type is set to None, a large variation in channel powers is observed between the left and right sides of the center channel. Variations are also noted in the channels powers of all channels with the Per Spectral Acquisition Bandwidth property.
||Measurement values for DF2 vary a lot over DF2 RBW Filter Type as compared to the variance of DF1 measurements over DF1 RBW Filter Type
If you set the RBW filter type to Gaussian, the DF2 measurement values are low.
||DEVM measurements in loop back gradually degrade and fail as the payload length on generator is reduced from maximum to 1 (for all supported packet types)
DEVM measurements in loop back give an expected result only when generated for the maximum packet payload length. The measurements gradually degrade and fail as the packet length is decreased.
||EV3 packet type is not supported for all modulation types
The toolkit does not support the EV3 packet type for all modulation types.
Contact NI regarding this document or issues in the document. If you contact NI in regards to a specific issue, reference the ID number given in the document. The ID number contains the current issue ID number as well as the legacy ID number (use the current ID number when contacting NI). You can contact us through any of the normal support channels including phone, email, or the discussion forums. Visit ni.com/contact if you find a workaround for an issue that is not listed in the document.