Communication Between Two GPIB Devices on One Computer

Publish Date: Feb 08, 2018 | 0 Ratings | 0.00 out of 5 | Print | Submit your review

Overview

This article discusses communication from one GPIB device (GPIB0) to another GPIB device (GPIB1) installed in a single PC.

1. Introduction

The example discussed below shows how to communicate between two GPIB devices on the same computer. We will use an AT-GPIB/TNT+ configured as the controller and a PCI-GPIB configured as the non-controller. The specific settings for these boards are:

  • AT-GPIB/TNT+: GPIB0, PAD = 0, SAD = None, controller


  • PCI-GPIB: GPIB1, PAD = 1, SAD = None, non-controller


 


For the example, we will use two IBIC (Instrument Bus Interactive Control) sessions--one for the controller(GPIB0), and another for the non-controller(GPIB1) (you can start these sessions from the start menu or through MAX). We then connect GPIB0 to GPIB1 as if GPIB1 was a device (dev1). Enter the following commands to see communication between the two devices:

 

IBIC on GPIB0:

IBIC on GPIB1:

ibfind gpib0

ibfind gpib1

ibsic (make sure the CIC flag is up*)

 

ibrsc 1

 

ibsre 1

 

ibfind dev1

 

ibwrt "Message from GPIB0"

 
 

ibrd 18

 

ibwrt "Message from GPIB1"

ibrd 18


 

* If the Controller-In-Charge (CIC) flag does not go up, it may be because GPIB1 is set as the system controller. In order to fix this problem, unplug the cable connecting the 2 boards and enter the following commands in IBIC for GPIB0:


ibfind gpib (if not already entered)
ibrsc 1
ibsic (at this point, the CIC flag should pop up)


Now reconnect the cable to GPIB1.

ibsic


This time, the CIC flag should still be up, meaning that this board is the CIC.

Back to Top

Bookmark & Share


Ratings

Rate this document

Answered Your Question?
Yes No

Submit