Academic Company Events NI Developer Zone Support Solutions Products & Services Contact NI MyNI

Classes in the Hartford Area

National Instruments scheduled courses in the Hartford area are held at Bloomy Controls Inc. in Windsor, CT. Bloomy Controls Inc. has demonstrated excellence by meeting and maintaining the requirements to be an official National Instruments Certified Training Center (NICTC). Below you will find a map and other pertinent information that may be helpful. Please contact National Instruments directly to inquire about availability or to register for all classes.

Bloomy Controls, Inc.
839 Marshall Phelps Road
Windsor, CT 06095
(860) 298 9925
(860) 298 9535 (Fax)

Upcoming National Instruments scheduled courses.
Additional Courses offered by Bloomy Controls.

Accommodations

Baymont Inn & Suites (~6 miles)
64 Ella Grasso Turnpike, Windsor Locks, CT
860-623-3336

Courtyard by Marriott (~2 miles)
1 Day Hill Road, Windsor, CT
860-683-0022

Hilton Garden Inn (~2 miles)
555 Corporate Drive, Windsor, CT
860-688-6400

Residence Inn (~2 miles)
100 Dunfey Lane, Windsor, CT
860-688-7474

Fairfield Inn (~6 miles)
2 Loten Drive, Windsor Locks, CT
860-627-9333

Homewood Suites (~6 miles)
65 Ella Grasso Turnpike, Windsor Locks, CT
860-627-8463

Directions

Traveling North on I-91 (from Hartford):
Take Exit 38 (Route 75/Poquonock Road). Turn right at the light at the end of the exit ramp onto Route 75. Proceed through three traffic lights and then bear right onto Day Hill Road. Driving through two traffic lights, remain on Day Hill Road for approximately one mile. At the third traffic light, turn left onto Marshall Phelps Road. Continue on Marshall Phelps Road for approximately 1/2 mile, and Bloomy Controls will be on the left hand side at 839 Marshall Phelps Road.

Traveling South on I-91 (from Bradley Airport/Springfield):
Take Exit 38B (Day Hill Road). Driving through two traffic lights, remain on Day Hill Road for approximately one mile. At the third traffic light, turn left onto Marshall Phelps Road. Continue on Marshall Phelps Road for approximately 1/2 mile, and Bloomy Controls will be on the left hand side at 839 Marshall Phelps Road. View a map to Bloomy Controls Inc.