SCXI Troubleshooting Resource

SCXI Quick Start Guide Reference

SCXI Terminal Block Compatibility

Information about SCXI terminal blocks and their compatible SCXI modules can be found in the SCXI Terminal Blocks Data Sheet.

Cable Assembly / Adapters

The measurement device and coinciding SCXI chassis cabling are located in the SCXI Cable Assemblies Data Sheet.

Jumper Configurable SCXI Modules, Terminal Blocks, and Chassis

Some of the modules, terminal blocks, and chassis require jumper configuration. These configurations can be found in the User Manual/Installation Guide for the module or terminal block. Below is a list of the jumper configurable SCXI modules and terminal blocks and the links to the corresponding manuals.

SCXI Terminal Block Compatibility Table

SCXI Modules	Jumper Configurable Settings	User Manual link
SCXI-1100	Input Signal Referencing Lowpass Filter Output Reference*	SCXI-1100 User Manual
SCXI-1120/D	Gain Filter Output Reference*	SCXI-1120/D User Manual
SCXI-1121	Gain Filter Voltage or Current Excitation Excitation Value Half-bridge Completion Output Reference*	SCXI-1121 User Manual
SCXI-1122	Output Reference*	SCXI-1122 User Manual
SCXI-1124	DIO or MIO Connection	SCXI-1124 User Manual
SCXI-1140	Gain Input Signal Reference Output Reference*	SCXI-1140 User Manual
SCXI-1141/2/3	Output Reference*	SCXI-1141/1142/1143 User Manual
SCXI-1160	DIO or MIO Connection	NI SCXI-1160/1161 Jumpers Note to Users
SCXI-1161	DIO or MIO Connection	NI SCXI-1160/1161 Jumpers Note to Users
SCXI-1162/HV	DIO or MIO Connection	SCXI-1162 User Manual
SCXI-1163/R	DIO or MIO Connection	NI 1163R Jumpers Note to Users
SCXI-1200	Output Polarity Input Range Input mode	SCXI-1200 User Manual

SCXI Modules	Jumper Configurable Settings	User Manual link
SCXI-1304/1305	AC/DC Coupling Ground Referencing	SCXI-1305 AC/DC Coupling BNC Terminal Block Installation Guide
SCXI-1321	Nulling Enable	SCXI-1321 Offset-Null and Shunt-Calibration High-Voltage Terminal Block Installation Guide
SCXI-1327	Signal Attenuation	SCXI-1327 High-Voltage Attenuator Installation Guide

SCXI Modules	Jumper Configurable Settings	User Manual link
SCXI- 1000/1001	Chassis Address**	SCXI Chassis User Manual
SCXI-1000DC	Chassis Address	SCXI Chassis User Manual
SCXI-2400	Baud Rate Chassis Address	SCXI-2400 User Manual

* The default setting for the PGIA Output Reference jumper will work for all E-series and M-series boards, so setting this jumper is not required unless you are using legacy MIO boards to control the SCXI chassis.

** Older revisions of the SCXI-1000/1001 have jumper a configurable chassis address. See KnowledgeBase Is the Old SCXI-1000 Jumperless Chassis Supported by the Most Recent Version of NI-DAQ? for more information.

Links to Associated SCXI Information

SCXI Support Page

SCXI Installation and Configuration Wizard

NI-DAQ Driver Support for SCXI Modules

How Can I Address and Use Cold Junction Compensation (CJC) with SCXI Modules?

SCXI Quick Start Guide

SCXI Accuracy Calculator

NI Calibration Services