Table Of Contents

FD-11614 Front Panel

Version:
    Last Modified: April 17, 2018

    Front Panel

    1. Power IN Connector
    2. Power LED
    3. Ethernet Port 0 and LED
    4. Bank 1 Thermocouple Connectors 0 through 7 and LEDs
    5. Bank 2 Thermocouple Connectors 0 through 7 and LEDs
    6. Mounting Holes
    7. Power OUT Connector
    8. STATUS LED
    9. Ethernet Port 1 and LED
    10. SYNC Logo

    Power Connector and LED


    Table 1. Signal Descriptions
    Pin Number Signal Description
    1 V Positive voltage line
    2 Aux2 Optional line for powering non-FieldDAQ devices
    3 C Common. Negative voltage line
    4 Aux1 Optional line for powering non-FieldDAQ devices
    5 Chassis Ground. This terminal is internally connected to the C terminal.
    Table 2. LED State/Device Status
    LED State Device Status
    On Device is receiving adequate power for its tasks.
    Off Device is unpowered or receiving inadequate power.

    Ethernet Connectors and LEDs


    Table 3. Signal Descriptions
    Pin Number Wire Color Gigabit Ethernet Signal Fast Ethernet Signal
    1 Orange/White BI_DA+ TX+
    2 Orange BI_DA- TX-
    3 Green/White BI_DB+ RX+
    4 Green BI_DB- RX-
    5 Brown/White BI_DD+ No Connect
    6 Brown BI_DD- No Connect
    7 Blue/White BI_DC+ No Connect
    8 Blue BI_DC- No Connect
    Table 4. LED State/Device Status
    LED State Device Status
    On Ethernet link
    Blinking, fast (12 blinks/s) Ethernet activity. Connected at 1,000 Mbit/s.
    Blinking, moderate (6 blinks/s) Ethernet activity. Connected at 100 Mbit/s.
    Blinking, slow (3 blinks/s) Ethernet activity. Connected at 10 Mbit/s.
    Off No Ethernet connection

    Thermocouple Connectors and LEDs


    Table 5. Signal Descriptions
    Signal Description
    TC- Negative thermocouple terminal
    TC+ Positive thermocouple terminal
    Table 6. LED State/Thermocouple Status
    LED Color and State Thermocouple Status
    Red, solid Open thermocouple detected
    Green, solid Thermocouple connected
    Yellow, blinking/alternating User-defined status. Use MAX to write a state to any LED by expanding Devices and Interfaces»Network Devices»your FieldDAQ device»bank of connectors in your FieldDAQ device and configuring the LED settings on the Settings tab.

    STATUS LED

    Table 7. LED State/Device Status
    LED Color and State Device Status
    Off Device is reserved by NI-DAQmx, but there is no activity, the device is not powered, or the device is not reserved by NI-DAQmx.
    Yellow, solid Device firmware is booting or updating.
    Red, blinking Device has reset to factory default or the firmware image is corrupted.
    Green, solid Device is reserved and a DAQ task is running.

    Recently Viewed Topics