Table Of Contents

XNET Write (G Dataflow)

Version:
    Last Modified: March 13, 2017

    Writes data to the network using an XNET session.

    Frame

    node_icon
    Writes data to a session as an array of CAN frames. The session must use a CAN interface and a mode of Frame Output Stream, Frame Output Queued, or Frame Output Single-Point.
    node_icon
    Writes data to a session as an array of FlexRay frames. The session must use a FlexRay interface and a mode of Frame Output Queued or Frame Output Single-Point.
    node_icon
    Writes data to a session as an array of LIN frames. The session must use a LIN interface and a mode of Frame Output Stream, Frame Output Queued, or Frame Output Single-Point.
    node_icon
    Writes data to a session as an array of raw bytes.

    Signal

    node_icon
    Writes data to a session of Signal Output Single-Point mode.
    node_icon
    Writes data to a session of Signal Output Waveform mode. The data represents a waveform of resampled values for each signal in the session.
    node_icon
    Writes data to a session of Signal Output XY mode. The data represents a sequence of signal values for transmit using each frame's timing as the database specifies.

    State

    node_icon
    Writes a request for the FlexRay interface to transmit a symbol on the FlexRay bus. You can use this XNET Write node with any input or output session for FlexRay.

    LIN

    node_icon
    Write a request for the LIN interface to change the diagnostic schedule. You can use this XNET Write node with any input or output session for LIN.
    node_icon
    Writes a request for the LIN interface to change the running schedule. You can use this XNET Write node with any input or output session for LIN.

    Recently Viewed Topics