Table Of Contents

XNET Write (State » FlexRay Symbol) (G Dataflow)

Version:
    Last Modified: February 22, 2017

    Writes a request for the FlexRay interface to transmit a symbol on the FlexRay bus. You can use this XNET Write node with any input or output session for FlexRay.

    connector_pane_image
    datatype_icon

    session in

    The session to use for the symbol write. This session is selected from the LabVIEW project or returned from XNET Create Session. The session must use a FlexRay interface.

    datatype_icon

    error in

    Error conditions that occur before this node runs. The node responds to this input according to standard error behavior.

    Default: No error

    datatype_icon

    session out

    An output that is the same as session in, provided for use with subsequent nodes.

    datatype_icon

    error out

    Error information. The node produces this output according to standard error behavior.

    Description

    You can use XNET Write (State FlexRay Symbol) with any XNET session mode, as long as the session interface is FlexRay. Because the symbol write applies to the FlexRay interface, it can apply to multiple sessions.

    After calling XNET Write (State FlexRay Symbol), the XNET interface transmits the symbol during the symbol window of the FlexRay cycle following the currently executing cycle. If you call XNET Write (State FlexRay Symbol) multiple times, only the most recent symbol is transmitted.

    Where This Node Can Run:

    Desktop OS: Windows

    FPGA: Supported


    Recently Viewed Topics