Table Of Contents

XNET Write (Signal » Single-Point) (G Dataflow)

Version:
    Last Modified: February 22, 2017

    Writes data to a session of Signal Output Single-Point mode.

    connector_pane_image
    datatype_icon

    session in

    The session to write. This session is selected from the LabVIEW project or returned from XNET Create Session. The session mode must be Signal Output Single-Point.

    datatype_icon

    data

    An input that provides a one-dimensional array of signal values.

    Each signal value is scaled, 64-bit floating point.

    Each array element corresponds to a signal configured for the session. The order of signals in the array corresponds to the order in the session list.

    The data provides the value for the next transmit of each signal. If XNET Write (Signal Single-Point) is called twice before the next transmit, the transmitted frame uses signal values from the second call to XNET Write (Signal Single-Point).

    A trigger signal written a value of 0.0 suppresses writing of its frame’s data; writing a value not equal to 0.0 enables it.

    datatype_icon

    error in

    Error conditions that occur before this node runs. The node responds to this input according to standard error behavior.

    Default: No error

    datatype_icon

    session out

    An output that is the same as session in, provided for use with subsequent nodes.

    datatype_icon

    error out

    Error information. The node produces this output according to standard error behavior.

    Where This Node Can Run:

    Desktop OS: Windows

    FPGA: Supported


    Recently Viewed Topics