Table Of Contents

Using NI-USRP in LabVIEW NXG and LabVIEW Communications System Design Suite

Last Modified: July 10, 2019

Complete the following steps to develop an NI-USRP application in LabVIEW NXG or LabVIEW Communications System Design Suite:

  1. Open an existing or new VI.
  2. Select the Diagram tab.
  3. From the palette, locate the NI-USRP nodes at Hardware Interfaces»Wireless Design and Test»NI-USRP.
  4. Select the nodes that you want to use and place them on the diagram to build your application.

Recently Viewed Topics