Table Of Contents

Accessing Properties

Last Modified: May 14, 2020

In LabVIEW, LabVIEW NXG, and LabVIEW Communications System Design Suite, you can find properties in niUSRP Properties. To access them, complete the following steps:

  1. Open a block diagram.
  2. Navigate to the NI-USRP palette.
    • In LabVIEW, navigate to Instrument I/O» Instrument Drivers» NI-USRP , and then place niUSRP Properties on the block diagram.
    • In LabVIEW NXG and LabVIEW Communications System Design Suite, select the Diagram tab. From the palette, navigate to Hardware Interfaces» Wireless Design and Test» NI-USRP» niUSRP Properties , and then place niUSRP Properties on the block diagram.
  3. Left-click niUSRP Properties and select the property you want to use.
  4. To add properties, resize niUSRP Properties.

Recently Viewed Topics