Table Of Contents

Route Scan Advanced Output (G Dataflow)

Version:
    Last Modified: March 3, 2017

    Routes the scan advanced output trigger from a trigger bus line (TTLx) to the front or rear connector.

    Use this node when handshaking with a switch module that is not directly cabled to the controller. In this module's session, set the scan advanced output bus line to a trigger bus line. In the cabled module's session, use this node to route from the trigger bus line to the front or rear connector of the cabled module.

    Programming Patterns

    If this node is used to route scan advanced from a TTL line, specify the TTL line as the scan advanced output destination in the niSwitch Configure Scan Trigger node.

    connector_pane_image
    datatype_icon

    invert

    Boolean input that reverses the input trigger signal from rising to falling and falling to rising.

    TRUE Reverses the input trigger signal.
    FALSE Does not reverse the input trigger signal.

    Default: FALSE (0)

    datatype_icon

    session in

    Control that identifies a particular NI-SWITCH session established with the niSwitch Initialize With Topology node, the niSwitch Initialize With Options node, or the niSwitch Initialize node.

    datatype_icon

    error in

    Error conditions that occur before this node runs.

    The node responds to this input according to standard error behavior.

    Standard Error Behavior

    Many nodes provide an error in input and an error out output so that the node can respond to and communicate errors that occur while code is running. The value of error in specifies whether an error occurred before the node runs. Most nodes respond to values of error in in a standard, predictable way.

    error in does not contain an error error in contains an error
    If no error occurred before the node runs, the node begins execution normally.

    If no error occurs while the node runs, it returns no error. If an error does occur while the node runs, it returns that error information as error out.

    If an error occurred before the node runs, the node does not execute. Instead, it returns the error in value as error out.

    Default: No error

    datatype_icon

    scan advanced output connector

    Destination of the Scan Advanced Output. Valid locations are the front and rear connectors.

    datatype_icon

    scan advanced output bus line

    Trigger line that routes the scan advanced output trigger from the front or rear connector. Select None (default) to break an existing route.

    Default: None

    datatype_icon

    session out

    Indicator that identifies a particular NI-SWITCH session established with the niSwitch Initialize With Topology node, the niSwitch Initialize With Options node, or the niSwitch Initialize node and used for all subsequent NI-SWITCH calls.

    datatype_icon

    error out

    Error information.

    The node produces this output according to standard error behavior.

    Standard Error Behavior

    Many nodes provide an error in input and an error out output so that the node can respond to and communicate errors that occur while code is running. The value of error in specifies whether an error occurred before the node runs. Most nodes respond to values of error in in a standard, predictable way.

    error in does not contain an error error in contains an error
    If no error occurred before the node runs, the node begins execution normally.

    If no error occurs while the node runs, it returns no error. If an error does occur while the node runs, it returns that error information as error out.

    If an error occurred before the node runs, the node does not execute. Instead, it returns the error in value as error out.

    Where This Node Can Run:

    Desktop OS: Windows

    FPGA: Not supported


    Recently Viewed Topics