Table Of Contents

Configure Scan List (G Dataflow)

Version:
    Last Modified: March 3, 2017

    Configures the scan list and scan mode used for scanning.

    The scan list is comprised of a list of channel connections separated by semicolons. For example, the following scan list will scan the first three channels of a multiplexer:

    com0>ch0; com0>ch1; com0>ch2;

    Programming Patterns

    To see the status of the scan, call either the niSwitch Switch Is Scanning node or the niSwitch Wait For Scan To Complete node. Use the niSwitch Configure Scan Trigger node to configure the scan trigger, and the niSwitch Initiate Scan node to start the scan.

    connector_pane_image
    datatype_icon

    session in

    Control that identifies a particular NI-SWITCH session established with the niSwitch Initialize With Topology node, the niSwitch Initialize With Options node, or the niSwitch Initialize node.

    datatype_icon

    error in

    Error conditions that occur before this node runs.

    The node responds to this input according to standard error behavior.

    Standard Error Behavior

    Many nodes provide an error in input and an error out output so that the node can respond to and communicate errors that occur while code is running. The value of error in specifies whether an error occurred before the node runs. Most nodes respond to values of error in in a standard, predictable way.

    error in does not contain an error error in contains an error
    If no error occurred before the node runs, the node begins execution normally.

    If no error occurs while the node runs, it returns no error. If an error does occur while the node runs, it returns that error information as error out.

    If an error occurred before the node runs, the node does not execute. Instead, it returns the error in value as error out.

    Default: No error

    datatype_icon

    scan list

    Scan list to use. NI-SWITCH uses this value to set the Scan List property.

    datatype_icon

    scan mode

    Control that specifies how the switch module breaks existing connections when scanning. NI-SWITCH uses this value to set the Scan Mode property.

    Default: Break Before Make

    datatype_icon

    session out

    Indicator that identifies a particular NI-SWITCH session established with the niSwitch Initialize With Topology node, the niSwitch Initialize With Options node, or the niSwitch Initialize node and used for all subsequent NI-SWITCH calls.

    datatype_icon

    error out

    Error information.

    The node produces this output according to standard error behavior.

    Standard Error Behavior

    Many nodes provide an error in input and an error out output so that the node can respond to and communicate errors that occur while code is running. The value of error in specifies whether an error occurred before the node runs. Most nodes respond to values of error in in a standard, predictable way.

    error in does not contain an error error in contains an error
    If no error occurred before the node runs, the node begins execution normally.

    If no error occurs while the node runs, it returns no error. If an error does occur while the node runs, it returns that error information as error out.

    If an error occurred before the node runs, the node does not execute. Instead, it returns the error in value as error out.

    Where This Node Can Run:

    Desktop OS: Windows

    FPGA: Not supported


    Recently Viewed Topics