Table Of Contents

Configure Equalization Filter Coefficients (G Dataflow)

Version:
    Last Modified: March 3, 2017

    Configures the custom coefficients for the equalization finite impulse response (FIR) filter on the device.

    The FIR filter is designed to compensate the input signal for artifacts introduced to the signal outside of the digitizer. Because this filter is a generic FIR filter, any coefficients are valid.

    spd-note-note
    Note  

    This node can be used only with high-speed digitizers that support onboard signal processing (OSP).

    connector_pane_image
    datatype_icon

    session in

    Identifies a particular instrument session.

    datatype_icon

    error in

    Error conditions that occur before this node runs.

    The node responds to this input according to standard error behavior.

    Standard Error Behavior

    Many nodes provide an error in input and an error out output so that the node can respond to and communicate errors that occur while code is running. The value of error in specifies whether an error occurred before the node runs. Most nodes respond to values of error in in a standard, predictable way.

    error in does not contain an error error in contains an error
    If no error occurred before the node runs, the node begins execution normally.

    If no error occurs while the node runs, it returns no error. If an error does occur while the node runs, it returns that error information as error out.

    If an error occurred before the node runs, the node does not execute. Instead, it returns the error in value as error out.

    Default: No error

    datatype_icon

    channels

    The channel from which to acquire data.

    Channel String Syntax

    You can input channels with the following options:
    • A single channel, such as 0
    • A list of channels, such as 0,1 or 3,2,1,0.
    • A range of channels, such as 0-7 or 0:7.
    spd-note-note
    Note  

    The order of channels in a list is important. The data for each channel is returned in the order the channels occur in the list.

    datatype_icon

    coefficients

    The custom coefficients for the equalization FIR filter on the device.

    These coefficients should be between +1 and -1. You can obtain the number of coefficients from the Equalization Num Coefficients property. The Equalization Filter Enabled property must be set to True to enable the filter.

    datatype_icon

    session out

    Passes the instrument handle to the next node in the program. This parameter has the same value as session in.

    datatype_icon

    error out

    Error information.

    The node produces this output according to standard error behavior.

    Standard Error Behavior

    Many nodes provide an error in input and an error out output so that the node can respond to and communicate errors that occur while code is running. The value of error in specifies whether an error occurred before the node runs. Most nodes respond to values of error in in a standard, predictable way.

    error in does not contain an error error in contains an error
    If no error occurred before the node runs, the node begins execution normally.

    If no error occurs while the node runs, it returns no error. If an error does occur while the node runs, it returns that error information as error out.

    If an error occurred before the node runs, the node does not execute. Instead, it returns the error in value as error out.

    Where This Node Can Run:

    Desktop OS: Windows

    FPGA: Not supported


    Recently Viewed Topics