Table Of Contents

Adjust Internal Reference Calibration (G Dataflow)

Version:
    Last Modified: March 3, 2017

    For the NI 5911, this function externally calibrates the internal reference. This function uses the external reference source instead of the internal reference source to calibrate the vertical range and offset. The internal source voltage is measured, and this value is stored and used for subsequent self-calibrations.

    spd-note-note
    Note  

    Use this function only when following the NI 5911 Calibration Procedure (Start»Programs»National Instruments»NI-SCOPE»Documentation»Calibration).

    connector_pane_image
    datatype_icon

    session in

    The instrument handle that you obtain from Start Calibration. The handle identifies a particular instrument session.

    datatype_icon

    error in

    Error conditions that occur before this node runs.

    The node responds to this input according to standard error behavior.

    Standard Error Behavior

    Many nodes provide an error in input and an error out output so that the node can respond to and communicate errors that occur while code is running. The value of error in specifies whether an error occurred before the node runs. Most nodes respond to values of error in in a standard, predictable way.

    error in does not contain an error error in contains an error
    If no error occurred before the node runs, the node begins execution normally.

    If no error occurs while the node runs, it returns no error. If an error does occur while the node runs, it returns that error information as error out.

    If an error occurred before the node runs, the node does not execute. Instead, it returns the error in value as error out.

    Default: No error

    datatype_icon

    option

    Not defined.

    datatype_icon

    stimulus

    The voltage of the applied DC signal.

    datatype_icon

    session out

    Passes the instrument handle to the next node in the program. This parameter has the same value as session in.

    datatype_icon

    error out

    Error information.

    The node produces this output according to standard error behavior.

    Standard Error Behavior

    Many nodes provide an error in input and an error out output so that the node can respond to and communicate errors that occur while code is running. The value of error in specifies whether an error occurred before the node runs. Most nodes respond to values of error in in a standard, predictable way.

    error in does not contain an error error in contains an error
    If no error occurred before the node runs, the node begins execution normally.

    If no error occurs while the node runs, it returns no error. If an error does occur while the node runs, it returns that error information as error out.

    If an error occurred before the node runs, the node does not execute. Instead, it returns the error in value as error out.

    Where This Node Can Run:

    Desktop OS: Windows

    FPGA: Not supported


    Recently Viewed Topics